Unit Injectors; Injector Timing; Fuel Filter; Fuel Solenoid Assembly - Arctic Cat 700 Diesel ATV 2007 Service Manual

Unit Injectors

To service the unit injectors, see Top-Side Components
in Section 3.

Injector Timing

NOTE: For injector timing instructions, see
Top-Side Components in Section 3.

Fuel Filter

To replace the fuel filter, see Section 2.

Fuel Solenoid Assembly

NOTE: After troubleshooting the fuel solenoid
(see Section 5) if it is determined that replacement
is necessary, use the following procedure.
REMOVING
1. Remove the right-front inner splash panel; then
remove the V-belt cooling boot from the V-belt
housing.
2. Locate the fuel solenoid mounted on top of the
fuel filter head; then disconnect the spade connec-
tor from the solenoid.
Back
DE061A
Back to TOC
3. Remove the banjo-fitting bolts (A) and (B) and
remove the fuel solenoid. Account for four crush
washers.
INSTALLING
1. Using new crush washers, secure the fuel solenoid
to the filter housing with banjo-fitting bolt (B) and
tighten securely.
2. Secure the fuel hose to the fuel solenoid with new
crush washers and banjo-fitting bolt (A).
3. Connect the spade connector to the solenoid.
Back to Section TOC
DE647B
4
DE647A
DE647A
Next
4-3