Drive Selector; Front Differential Lock; Shift Lever - Arctic Cat 700 Diesel ATV 2007 Service Manual

INSTALLING
1. Place the return spring into the throttle control;
then place the bushing and actuator arm into posi-
tion. Secure with the cap screw, lock washer, and
washer.
2. Using a pair of needle-nose pliers, place the spring
into position on the actuator arm.
3. Place the two halves of the throttle control onto the
handlebars and secure with the two machine
screws.
ADJUSTING
To adjust throttle cable free-play, see Section 2.

Drive Selector

The automatic drive selector allows the operator to
operate in either 2-wheel drive (rear wheels) or
4-wheel drive (all wheels). For normal riding on flat,
dry, hard surfaces, 2-wheel drive should be sufficient.
In situations of aggressive trail conditions, 4-wheel
drive would be the desired choice.
To either engage or disengage the front wheels, move
the switch to the 4WD position or to the 2WD position.
Back
9-4
AF679D
AF680D
Back to TOC
! CAUTION
Do not attempt to either engage or disengage the
front differential while the ATV is moving.

Front Differential Lock

This ATV is equipped with a front differential lock.
The front differential lock allows the operator to
mechanically lock the differential to apply equal
power to both front wheels. To engage the front differ-
ential lock, rotate the handle fully clockwise to LOCK;
to disengage the front differential lock, rotate the han-
dle fully counterclockwise to UNLOCK.
To adjust the differential lock cable, see Section 2.

Shift Lever

REMOVING
1. Remove the E-clip securing the shift rod to the
engine shift arm.
2. Remove two cap screws, two self-tapping screws,
and three nylon ties securing the left-side splash
panel and remove the panel.
Back to Section TOC
738-422A
KX016A
Next