Promise Technology 1000f series Product Manual page 410

VessRAID 1000f, 1000i, 1000s Series Product Manual
Reported Event
PSU 12V/5V/3.3V power
is within the range
RAID Level Migration
RAID Level migration is
started
RAID Level migration is
completed
RAID Level migration is
paused
RAID Level migration is
resumed
RAID Level migration is
stopped
RAID Level migration has
encountered a physical
disk error
RAID Level migration is
aborted due to an internal
error.
RAID Level migration is
queued
Migration has detected/
cleared stale NV
Watermark
Array was incomplete due
to missing NV Watermark
Rebuild
Rebuild is started
Rebuild is completed
Rebuild is paused
Normal.
Result of settings or user action. Normal.
Normal.
Migration paused because of user intervention,
schedule or a higher priority background activity.
Migration has resumed again after a pause.
Migration stopped because of user intervention,
schedule or the logical drive was deleted or went
critical or offline.
Bad block found on a disk drive. Migration will finish.
Check the disk drive check table after migration and
replace disk drive as needed.
System resources are low. Reduce system load or
restart the VessRAID. See page 134 (WebPAM
PROe) or page 288 (CLU).
Migration has been set manually or by schedule.
Watermarks are progress markers left as the result of
interrupted RAID migrations. If the watermark was
cleared, migration should finish.
RAID migration was interrupted by a shutdown.
If array is online, try migration again. See page 162
(WebPAM PROe) or page 237 (CLU).
If array is offline, delete and recreate array. See
page 158 and page 153 (WebPAM PROe) or
page 234 and page 230 (CLU).
Result of settings or user action. Normal.
Normal.
Rebuild paused because of user intervention,
schedule or a higher priority background activity.
390
Corrective Action