If the battery does not maintain normal values after a Recondition, replace the
battery. See "Replacing the Cache Battery" on page 324.
VessRAID automatically reconditions the battery every two months. To set the
schedule, see "Scheduling an Activity" on page 74.
When you install a new battery, the cycle count shows 0. VessRAID automatically
runs a recondition on the battery to verify it. If you restart the subsystem or
controller before reconditioning is finished, the battery is charged to 100%, then
reconditioning starts again.
Reconditioning a Battery
A cache backup battery or Battery Backup Unit (BBU) is optional on VessRAID.
To recondition the battery:
1.
Click the Subsystem
2.
Click the Enclosures
3.
Click the Enclosure
4.
Click the Battery tab in Management View.
5.
From the Battery tab dropdown menu, choose Recondition.
6.
Click the Submit button.
Reconditioning fully discharges, then fully recharges the battery. During
reconditioning, if the Adaptive Writeback Cache function is enabled, the
controller cache is set to Write Thru. After reconditioning, the cache is reset
to Write Back. See "Making Controller Settings" on page 136.
VessRAID automatically reconditions the battery every two months. To set
the recondition schedule, see "Scheduling an Activity" on page 74.
Making Buzzer Settings
To make buzzer settings:
1.
Click the Subsystem
2.
Click the Enclosures
3.
Click the Enclosure
4.
In Management View, from the Buzzer tab dropdown menu, choose
Settings.
5.
Check the Buzzer Enable box to enable the buzzer.
Uncheck the Buzzer Enable box if you do not want the buzzer to sound.
6.
Click the Submit button.
Chapter 4: Management with WebPAM PROe
icon in Tree View.
icon.
icon.
icon in Tree View.
icon.
icon.
143