Turn off both power supply switches when the following this message appears:
Shutdown complete. It is now safe to power off the subsystem.
Powering Off the VessRAID – Telnet Connection
This option enables you to start the VessRAID NAS from SmartNAVI.
The Wake on LAN option must be enabled. See "Making Management Port
Settings" on page 248.
To power off the VessRAID:
1.
From the Main Menu, highlight Additional Info and Management and press
Enter.
2.
Highlight Shutdown or Restart and press Enter.
3.
Highlight Option and press the spacebar to display Poweroff.
4.
Highlight Submit and press Enter.
A warning message appears.
5.
Press Y to continue.
The screen goes blank.
6.
Wait for no less than two minutes.
Monitoring the Power-Off
To monitor a power-off, you must use the Command Line Interface (CLI) though a
serial connection to the VessRAID.
When you see the message: "Shutdown complete. It is now safe to power off the
subsystem" the subsystem is ready to power on. See "Powering On a NAS
Device" on page 187.
Shutting Down the VessRAID – Serial Connection
This function enables you to shutdown the VessRAID subsystem on a serial
connection. Additional action is required, as described below.
To shutdown the VessRAID:
1.
From the Main Menu, highlight Additional Info and Management and press
Enter.
2.
Highlight Shutdown or Restart and press Enter.
After you power off the subsystem, wait at least 10 seconds before
you power on the subsystem again.
Chapter 6: Management with the CLU
Caution
285