Replacing A Power Supply; Vessraid 1700 Series; Vessraid 1800 Series - Promise Technology 1000f series Product Manual
Fc, iscsi, sas external disk array subsystems
Hide thumbs
Also See for 1000f series:
- Product manual (28 pages) ,
- Product manual (438 pages) ,
- Quick start manual (472 pages)
Table of Contents
Advertisement
Replacing a Power Supply
VessRAID 1700 Series
The power supply on the VessRAID 1700i/s models is not replaceable onsite. If
you need to replace the power supply, contact Technical Support and make
arrangements to return the subsystem to Promise for service. See page 411.
VessRAID 1800 Series
The redundant power supplies on the VessRAID 1800f/i/s models are designed
as field-replaceable units. You can replace a power supply without removing the
VessRAID from the rack.
Figure 1. Replacing a Power Supply
Retaining screw
Retaining screw
A 1840 Series power supply is shown.The 1830 Series is similar.
Removing the old power supply
To remove the power supply:
1.
Verify that the power supply LED is amber or red.
See Figure 1.
2.
Switch off the power to the power supply you plan to replace.
3.
Unplug the power cord.
4.
Loosen and remove the retaining screw on the left side of the power supply.
5.
Pull the power supply out of the VessRAID enclosure.
Installing the new power supply
To install the power supply:
1.
Carefully slide the power supply into the enclosure.
2.
Install and tighten the retaining screw on the left side of the power supply.
3.
Plug in the power cord.
4.
Switch on the power supply.
5.
Verify that the new power supply LED is green.
This completes the power supply replacement procedure.
Power supply LEDs
Power supply LEDs
319
Chapter 8: Maintenance
Advertisement
Table of Contents
