Restarting Subsystem Over A Serial Connection - Promise Technology 1000f series Product Manual
Fc, iscsi, sas external disk array subsystems
Hide thumbs
Also See for 1000f series:
- Product manual (28 pages) ,
- Product manual (438 pages) ,
- Quick start manual (472 pages)
Table of Contents
Advertisement
VessRAID 1000f, 1000i, 1000s Product Manual
To restart the VessRAID subsystem on a Telnet connection:
1.
From the Main Menu, highlight Additional Info and Management, and press
Enter.
2.
Highlight Shutdown or Restart and press Enter.
3.
Press the spacebar to display Restart then press Enter.
A warning message appears.
4.
Press Y to continue.
The screen will go blank.
5.
Wait for two to three minutes.
6.
Re-establish your Telnet connection to the VessRAID CLU.
If you cannot re-establish a connection, wait 30 seconds, then try again.
Restarting Subsystem over a Serial Connection
To restart the VessRAID subsystem on a serial connection:
1.
From the Main Menu, highlight Additional Info and Management, and press
Enter.
2.
Highlight Shutdown or Restart and press Enter.
3.
Press the spacebar to display Restart then press Enter.
A warning message appears.
4.
Press Y to continue.
The screen will display shutdown and startup functions.
5.
When the
Do not restart the VessRAID during a firmware upgrade
procedure. Wait until the upgrade is one and you are prompted to
restart.
prompt appears, log into the CLU again.
Login:
Warning
318
Advertisement
Table of Contents
