Promise Technology 1000f series Product Manual page 404

VessRAID 1000f, 1000i, 1000s Series Product Manual
Reported Event
Drive Interface Controller
Drive-interface controller
found
Drive-interface controller
is NOT found
Drive-interface
diagnostics has passed
Drive-interface
diagnostics has failed
Drive-interface controller
has generated a general/
data parity error.
Enclosure
Enclosure temperature is
above the threshold/
warning threshold
Enclosure temperature is
above the critical
threshold
Enclosure temperature is
within the normal range
Event Log
Event logging is enabled
Event logging is disabled Event logging has been disabled.
Event log buffer is cleared
in RAM
Event log buffer is cleared
in NVRAM
Event log buffer is cleared
in MDD
Host Interface Controller
Host-interface controller
has detected bus reset
Normal.
Restart the VessRAID. See page 134 (WebPAM
PROe) or page 288 (CLU). If this message appears
repeatedly, contact Technical Support. See page 411.
Normal.
Restart the VessRAID. See page 134 (WebPAM
PROe) or page 288 (CLU). If this message appears
repeatedly, contact Technical Support. See page 411
Drive-to-controller parity error. If this message
appears repeatedly, contact Technical Support. See
page 411.
The VessRAID is overheating. Check for airflow
around and through the VessRAID, and verify that all
fans are working. Replace fans as needed.
The VessRAID is seriously overheating. Check for
airflow around and through the VessRAID, and verify
that all fans are working. Replace fans as needed.
Normal.
Event logging has been successfully enabled.
The event log was cleared.
The non-volatile RAM event log was cleared.
The MDD (disk drive) event log was cleared.
The initiator sent a reset command. If this message
appears repeatedly, contact Technical Support. See
page 411.
384
Corrective Action