Promise Technology 1000f series Product Manual page 322

VessRAID 1000f, 1000i, 1000s Product Manual
3. Press the
4. Press the
5. Press the
6. Press the
number.
7. Press the
choose a physical drive for your array.
Note that you cannot mix HDDs and SSDs in the same disk array.
8. Press the
choices.
9. Press the
The display shows the array creation process. When the creation is finished,
the LCD returns to Disk Array Create.
Creating a Logical Drive
For more information on the choices below, see "Chapter 9: Technology
Background" on page 329.
To create a logical drive on your new disk array:
1. Press the
2. Press the
3. Press the
4. Press the
Note that the available RAID levels depend on the number of physical drives
in your disk array.
5. Press the
The display shows the maximum available capacity.
6. Press the
7. Press the
The display shows the default stripe size.
The choices are 64 KB, 128 KB, 256 KB, 512 KB, and 1 MB.
8. Press the
9. Press the
The display shows the default sector size.
The choices are 512 B; 1 KB, 2 KB, and 4 KB
or button until the display says Advanced Configure.
button and the display says Disk Array Create.
button again and the display says Physical Drive Select.
button again to display the available physical drives by
button to move through the list. Press the
button to move to END and press the
button again to confirm.
button and the display says Logical Disk Create.
button again and the display says 000.
button again and the display says RAID Level.
or button until the display shows the RAID level you want.
button to choose the RAID level shown on the screen.
or button until the display shows the capacity you want.
button to choose the capacity shown on the screen.
or button until the display shows the stripe size you want.
button to choose the stripe size shown on the screen.
302
button to
button to input your