Promise Technology 1000f series Product Manual page 392

VessRAID 1000f, 1000i, 1000s Series Product Manual
LEDs
Controller
Status
Dirty Cache
Battery
Fan
USB Ports
SAS OUT
Port
If the Controller Status LED is amber, restart the VessRAID. See "Restarting the
Subsystem" on page 134 (WebPAM PROe) or page 288 (CLU).
If the Controller Status LED continues to display amber after startup, contact
PROMISE Technical Support. See page 411.
The Dirty Cache LED flashes during input/output operation. If the LED shines
amber and the power is off, there is unsaved data in the cache. Do NOT power
down the VessRAID while this LED is on. See "Browser Does Not Connect to
WebPAM PROe" on page 406 for more information.
If the Battery LED is amber or red, try reconditioning the battery. See
"Reconditioning a Battery" on page 143 or page 224. If the condition returns,
replace the battery.
If a Fan LED is amber or red:
1. Identify the malfunctioning fan. See "Viewing Enclosure Information" on
page 141 or page 221.
2. Replace the fan. See "Replacing a Cooling Fan" on page 321.
Also see "Enclosure Problems" on page 400.
Dark Green
no power
No data in
cache
Not
detected or
Not installed
Not
detected
No device Device
detected detected
No
connection connected
State
Amber
OK Error
Unsaved
— data
in cache
Backup
capacity
OK
below 72
hours
One fan
OK turning too
slowly
—
Port
—
372
Red Blinking
Malfunction Green:
at start-up Activity
Amber:
Unsaved
—
in cache
No power to
controller
cache
Multiple
fans turning
too slowly
Failed data Amber:
transfer Activity
Green:
—
Activity
data
—
—