Figure 11. RAID controller memory module
Retainer
4.
Align the new memory module with the memory slot so the groove lines up.
5.
Gently press the memory module into the slot until the retainers click into
locked position.
6.
Attach the RAID controller cover and install the two attaching screws.
See page 322, Figure 4.
7.
Reinstall the RAID Controller.
See "Replacing a RAID Controller" on page 320.
This completes the memory module replacement procedure.
Memory
Alignment
module
groove
327
Chapter 8: Maintenance
Memory
Retainer
slot