Conrod Crank Pin Bearing Inspection And Selection - Suzuki 2005 GSF1200 Service Manual

1D-62 Engine Mechanical:
Conrod Crank Pin Bearing Inspection and
Selection
Refer to "Conrod Removal and Installation: ".
Inspection
1) Inspect the bearing surfaces for any signs of fusion,
pitting, burn or flaws. If any, replace them with a
specified set of bearings.
2) Place the plastigauge axially along the crank pin,
avoiding the oil hole, as shown.
Special tool
(A): 09900–22301 (Plastigauge (0.025 -
0.076 mm))
3) Tighten the conrod cap nuts to the specified torque,
in two stages.
NOTE
• When installing the bearing cap to the
crank pin, make sure that the number "A"
on the conrod faces towards the intake
side.
• Never rotate the crankshaft or conrod
when a piece of plastigauge is installed.
Tightening torque
Conrod cap nut (Initial): 25 N·m (2.5 kgf-m, 18.0
lb-ft)
Conrod cap nut (Final): 51 N·m (5.1 kgf-m, 37.0
lb-ft)
B649G11406061
4) Remove the bearing caps and measure the width of
I649G1140278-01
(A)
I649G1140333-02
Selection
1) Check the corresponding conrod I.D. code numbers
"A"
the compressed plastigauge using the envelope
scale. This measurement should be taken at the
widest part of the compressed plastigauge.
If the oil clearance exceeds the service limit, select
the specified bearings from the bearing selection
table.
Conrod big end oil clearance
Standard: 0.032 – 0.056 mm (0.0013 – 0.0022 in)
Conrod big end oil clearance
Service limit: 0.080 mm (0.0031 in)
([1] or [2]) "A".
"A"
Conrod I.D. specification
Code "A"
1
2
I649G1140280-02
(A)
I649G1140334-01
I649G1140282-02
I.D. specification
41.000 – 41.008 mm
(1.6142 – 1.6145 in)
41.008 – 41.016 mm
(1.6145 – 1.6148 in)