87-95 Brake Power Booster; 96-04 Brake Hydro-Booster - Factory Five Racing Mk4 Roadster Assembly Manual

87-95 Brake Power Booster


Socket set, wrenches or box wrenches for brake lines, tube cutter, tape, and marker pen.

Mustang power booster push rod, brake light switch/spacer/clip.
Remove the brake rod retainer clip from the top of the brake pedal.
Remember the order in which these washers and spring clips are removed so that you can reinstall them
faster later.
Brake switch parts.
Remove the four bolts that retain the power booster to the firewall, these bolts also go through the pedal
box front mount plate inside the foot-box area.
Attach tape to the brake lines and mark their positions on the master cylinder and distribution block.
Leave the lines that go from the distribution block to the master cylinder in place.
Cut 4" into the hard brake lines from the distribution block. New brake line is provided with the kit.
The power booster/master cylinder assembly can now be taken out of the engine compartment.

96-04 Brake Hydro-booster


½" ratchet, Snap ring pliers, wrenches or box wrenches, tape, marker, bucket, rags.

Mustang Hydro-booster, master cylinder, and power booster hoses.
Remove the brake rod retainer clip from the top of the brake pedal.
Remember the order in which these washers and spring clips are removed so that you can reinstall them
faster later.
30
www.factoryfive.com 508-291-3443