1996-2004 Abs Brakes; 87-95 Steering Rack - Factory Five Racing Mk4 Roadster Assembly Manual
Hide thumbs
Also See for Mk4 Roadster:
- Assembly manual (553 pages) ,
- Assembly manual (551 pages) ,
- Assembly manual (523 pages)
Table of Contents
Advertisement
1997 Hydro-booster, Master cylinder, Hydro-boost retaining nut and snap ring.
1996-2004 ABS Brakes
If power brakes are going to be used, an addition that is optional and not necessary but is very useful is
the use of the ABS system from the Mustang. This does complicate the brake set-up but when driving
the car the difference is noticeable. The brake line fittings used on the controller and the Master
cylinder are single flare. If ABS is going to be used label the location of the brake lines and remove all
the brake lines in the front half of the car. This will minimize the number of flares needed. Remove the
ABS controller and mounting bracket from the engine bay.
87-95 Steering Rack
⅝",
11
/
" wrenches, needle nose pliers, hammer
16
Mustang steering rack assembly, rubber mounting bushings.
Remove the U-joint bolt from the steering column sleeve.
Remove the lower steering shaft by taking off the two bolts at the flexible collar in the area where the
splined steering rack shaft begins.
Remove the steering rack outer tie rod nuts and cotter pins. If the tie rod will not come out of the
spindles easily, use a hammer but be careful not to damage the threads.
32
www.factoryfive.com
508-291-3443
Advertisement
Table of Contents
