Optional Hood Hinge - Factory Five Racing Mk4 Roadster Assembly Manual

Drill 3 / " holes in the front ¾" tube through the mounting plate holes.
16
Rivet the plate to the front ¾" tube.
Change the angle of the mounting plate so that the hood pin post is perpendicular to the body hood lip.
Bend the front tab if necessary so that it sits flat on the radiator mount tube.
Tighten the carriage bolts holding the mounting plates.
For alignment purposes, adjust the height of the pins so that when the hood is on, the posts should just
barely touch the hood.
Put a small dab of silicone or white grease on each of the hood pin posts.
Center the hood in the opening and press down.
This should leave a couple of small silicone marks on the underside of the hood.
Drill two 7 / " holes through the hood where the marks are located.
16
Place the circular chrome plates, packaged with the hood posts, over the posts.
Drill the four mounting screw holes through the circular chrome plates with a
Screw the chrome plates to the hood using the short hood pin screws and a Phillips head screwdriver.
Raise the height of the posts so that they stick through the hood and the bottom of the hood pin hole is
even with the chrome plate surface. The pins can be removed and installed pointed in the direction
desired.
Tighten the hood pin post nuts.

Optional Hood Hinge


", ⅝" Drill bits, drill, measuring tape, rivet gun, marker,
3 / ", 7 /
16 64

Hood hinge
345
www.factoryfive.com 508-291-3443
3 / " drill bit.
32
3 / " hex key, ½" wrench
16