Quad shock Installation
Attach the body end of the Quad shock to the upper arm of the IRS with the supplied metric bolt.
Attach the shaft end of the Quad shock to the rear quad shock bracket hole on the frame using the
washer on the outside of the quad shock as shown in the picture.
Quadshock mounted to frame bracket.
Rear Calipers and Rotors
Push the slotted rotor onto the spindle.
Attach the caliper to the spindle using the OEM T-Bird bolts.
Width Adjustment
Mount your wheels and tires.
Lower the frame off the jack stands.
With the car on the ground, check the ride height of the car to the bottom of the 4" frame rail
Front: 4.25"-4.50"
Rear: Usually 4.75" with one person normally in the car or 5.00" with two people in the car.
Jack the rear of the car up and place on jack stands located on the lower control arms near the shock.
This supports the suspension at ride height.
140
www.factoryfive.com
508-291-3443