Place a washer onto the bolt.
Place the pulley wheel on the bolt.
Place the aluminum sleeve on the bolt with the flange towards the pulley wheel, so that it slides inside
the pulley.
Install the bolt assembly on the A/C bracket (previously drilled in the disassembly section), using the
lock nut provided.
Pull the tension pulley back with a pry bar carefully and install the fan belt. If the belt does not fit using
this routing, check to see if after-market under-drive pulleys have been fitted on any of the accessories
or the crankshaft, if so you may have to also use an after-market belt.
235
www.factoryfive.com
508-291-3443
Tensioner
Belt Routing