Fuel Filter And Connectors - Factory Five Racing Mk4 Roadster Assembly Manual

Lower the jack slowly with the rear end so that they come down together.
When the rear end has dropped down low enough, you can easily remove the coil springs and upper
rubber spring mount. Save the rubber bushings above and below the springs.
Remove the bolts and nuts from the lower rear Mustang control arm, where the arms are mounted to the
body/chassis.
Remove the bolts and nuts from the upper Mustang control arm, where the arms are mounted to the
body/chassis.
All of the arms should remain attached to the rear end assembly. Once off, place the bolts back into the
arms and attach nuts so they do not get lost.
Remove the rear end from under the car.
Remove the brackets that secure the quad shocks to the frame.
Use a drill with a ¼" bit to drill out the rivets on the brake bracket, which retain it to the body above the
differential. Keep this bracket for use later.

Fuel filter and connectors


Socket set, small flat head screwdriver, tin snips or razor knife.

Rear fuel lines and fuel filter mount.
Remove the fuel filter and fuel filter mount from the frame.
Disconnect the rear fuel line going from the tank to the filter and store.
Cut the plastic return line hose going to the tank 4" from the tank and store.
50
www.factoryfive.com 508-291-3443