Gauge Pod Installation - Factory Five Racing Mk4 Roadster Assembly Manual

Attach the constant control relay to the top of the passenger footbox using ⅛" rivets.

Gauge Pod Installation


Wire stripper, crimping tool, electrical tape, wire cutters, Phillips head screwdriver, hack saw,
razor knife, marker,

Mustang gauge cluster, black vinyl trim, dash electrical components, misc. electrical
components, mustang gauge conversion kit.

1999-2004 Mustangs require the gauge pod to be hooked up in order to run the car. This means
that if aftermarket gauges are used, the gauge pod will still need to be mounted behind the dash.

96-04 - If you are planning on flashing your computer to eliminate the PATS, you will not need
the gauge pod but you will need to have a 490Ω resistor in parallel with the dash charge indicator
light on the light green with red stripe wire in order for the battery to charge.

If you are using aftermarket gauges, skip the next section.

Once the Mustang Gauges are removed from the gauge pod, they no longer have any back
lighting unless bulbs are mounted behind the gauges once mounted in the dash.

This conversion kit is usually not packed unless specified. If you want it but did not receive it,
please call.
On the back side of the gauge pod, mark the gauge locations next to the metal clips that connect the
gauges to the circuit board.
/ ", 11 / " drill bits, drill, small Torx screwdriver.
1 8
64
www.factoryfive.com
219
508-291-3443