Dash Harness - Factory Five Racing Mk4 Roadster Assembly Manual

87-95 Dash Harness

The dash harness begins at the coil area and goes rearward to the large hole in the front of the driver's
side foot box.
The key to routing the dash harness is to start on the inside of the foot box and push the smaller items
through the large hole from the inside.
The connections for the coil, starter relay, and the connectors for the rest of the harness easily fit through
this hole and the big rubber grommet on the harness press fits into the laser cut hole.
Remove 4" of the tape covering the harness wires on the outside of the dash harness grommet.
Pull enough of the harness through the grommet so that the coil can still mount on the outside of the ¾"
tubing next to the master cylinder. By doing this, the amount of visible wiring in the engine bay is
reduced.
207
www.factoryfive.com 508-291-3443