Trunk Aluminum - Factory Five Racing Mk4 Roadster Assembly Manual

Mount the turn signal stalk with the stalk pointed towards the seat as high as possible between the plate
steel that also holds the windshield and the vertical ¾" tubing next to it. The switch spans the gap. Use
two 1" screws and a /
5
16
87-95 - The ignition switch mounts under the turn signal stalk on the 2"x 2" frame hoop that has the
door hinge mounted to it. With the door closed, mount the switch as close to the hinge as possible
without hitting it. Use two 1" screws and a
96-04 - The ignition switch will get mounted in the dash. Refer to the Mustang wiring diagrams to find
the correct wires to attach to the key switch.
The turn signal stalk can be cut shorter so that when it's mounted it will not protrude past the dash lip.
If you want to cut the stalk length, do it after the dash is installed and you have sat in the car to see if it
is needed. Cut half of the length first. Do not worry about the pieces that fall out, they are for the
Mustang wipers and are not used. Re-use the end cap and epoxy glue it to the newly cut stalk to give it a
nice finished look.

Trunk Aluminum


⅛" drill bit, silicone, rivet gun, caulk gun,

Mounted Aluminum, Packaged Aluminum, secondary body fasteners
Silicone and rivet in the trunk side panels.
Remove the rear bolt of the passenger side gas tank strap.
" socket and / " drill bit.
9
64
5 / " socket and
16
www.factoryfive.com
9 / " drill bit.
64
9 / " wrench, 5 / " hex key.
16 16
222
508-291-3443