Banjo Bolt Torque Specs; Wiring Harness - Factory Five Racing Mk4 Roadster Assembly Manual

Attach the hard brake line to the flexible brake line.

Make sure that your flex lines will not interfere with anything in the suspension, wheels during
travel or turning full lock to lock.
Tighten the banjo bolts on the calipers

Banjo bolt torque specs

87-95 Front Brake hose to caliper Banjo bolt – (34Nm) 25lbft
96-04 Front Brake hose to caliper Banjo bolt – (39Nm) 29lbft
Rear brake caliper hose to caliper Banjo bolt – (43Nm) 32lbft

When your system is finished being plumbed, go back and check all the fittings for tightness.
Fill the system with fluid and bleed being very thorough in checking for leaks.

Wiring Harness


⅜" socket, regular head screwdriver, slip joint pliers,
electrical tape, wire cutters.

Misc. electrical components, insulated clip hardware

If during this section, you decide to cut your harness, wait until after the car has been started then
remove sections one at a time, starting the car after each cut to make sure it runs. Helm electrical
201
www.factoryfive.com 508-291-3443
1 / 8 ", 3 / " drill bits, drill, #8 nut driver,
16