Factory Five Racing Mk4 Roadster Assembly Manual page 221

Remove the Mustang gauges from the white gauge pod with a small Torx screwdriver.
Cut the locating pins for the gauges off the white gauge pod with a hack saw so that the pod will lie
flush against the firewall when mounted.
Use an 11 / " drill bit and a steady hand to enlarge the holes in the gauge connectors on the back of the
64
gauge pod. This will help the male bullet connectors that come with the kit to seat in the holes.
Attach the male bullet connectors in the kit to one end of the wire extensions using a crimping tool.
Attach the blue butt connectors to the other end of the wire extensions using a crimping tool.
220
www.factoryfive.com 508-291-3443