Factory Five Racing Mk4 Roadster Assembly Manual page 54

Stock 94-04 front lower.
If using the stock 94-04 front lower control arms, drill a ½" hole in the spring seat area shown in the
picture below using the rear end shock mount as a guide for height. If the hole is drilled too low, you
will have to clearance the middle of the spring area so the shock will not hit when installed.
Remove the area, near the center of the spring mount to prevent damage to the coil-over unit thru any
contact whatsoever.
53
www.factoryfive.com 508-291-3443