Factory Five Racing Mk4 Roadster Assembly Manual page 129

Driver Side
Install the kit ½"x 4" bolts are provided for each lower shock mount. From the rear, the bolt goes
through the bracket, ⅛" shim, shock, then the long spacer (1.09") followed by the bracket and axle. Use
a ¾" socket and Torque wrench to tighten both upper and lower mounts to 40 ft-lbs.
Check for shock clearance on brake lines, emergency brake cables, brake calipers, frame and axle parts.
Check to make sure that the spring is seated correctly on the shock.
Mount the quad shocks and their brackets to the rectangular frame plate hanging under the 2"x 3" tube
behind the axle.
Attach the rear end axle straps (included with the kit). These cables will prevent drive shaft binding if
you happen to achieve airborne status. The rear end straps bolt to the front bolt of the quad shock up
high, and back side of the vertical shock down low.
128
www.factoryfive.com 508-291-3443