Coil-Over Shock Assembly - Factory Five Racing GTM Supercar Assembly Manual

Install the lower coil-over mount on the upper surface of the lower control arm. This bracket is installed
(FFR# 25714) using the Corvette 7mm shock mount hardware (this bracket is pitched inward). (same
procedure used on driver and passenger side)

Coil-Over Shock Assembly


flat head screw driver.

The shocks are pre-valved at the factory in compression. The shocks are not adjustable. The
shocks are custom valved FSD (Frequency Selective Dampening) shock absorbers. Front springs
are 450lb and rear springs are 750lb.

Coil-over parts.
Slide the coil sleeve over the body of the damper beginning at the end which has the rubber bump stop.
The coil-over hats have a "C" clip which affixes it into place. Remove this clip to assembly the coil over
assembly.
222
www.factoryfive.com 508-291-3443