Coil-Over Shock Assembly - Factory Five Racing '33 Hot Rod Assembly Manual

Insert the greased sleeve into the bushings in the upper control arm
Install the grease fittings into the pivot points on the upper control arm. Attach a grease gun onto the
grease fitting and fill with grease until the grease starts to seep out.

Coil-Over Shock Assembly


Snap ring pliers, ¾" wrench, ¾" socket, Ratchet, Torque wrench

Front shock set, Front shock set, Insulated clip hardware.
 The front shocks are pre-valved at the factory in compression and rebound for good street use. The
shocks can be adjusted in rebound as per Koni's instructions if so desired. The front springs are 400lb,
34
www.factoryfive.com 508-291-3443