Setting The Pen Carriage Movement Speed; Setting The Step Movement Distance - GRAPHTEC CUTTING PRO FC2250 Series User Manual

5.23 Setting the Pen Carriage Movement Speed

This setting determines how far and how fast the pen carriage moves when the [
used to move it. When one of the [
the specified distance. If the key is held down, the pen carriage moves slowly, but then moves more quickly
after moving the specified length (distance).
•
When the LCD parameter in the menu shown below is marked with a black dot [
displayed on the LCD when the [ ] [
FORCE
STEP
LOW SPEED
SPEED
•
Pressing the [NEXT] key while using the [
low speed and high speed. Use this function for more accurate positioning of the pen carriage.

Setting the Step Movement Distance

This setting determines the distance the tool head moves each time one of the keys is pressed. The setting
distance is an approximate measure of the distance actually moved.
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the [NEXT] key repeatedly until the following menu is displayed.
FORCE
OPTION1
SPEED
(3) Press the [F4] key (OPTION2) to display the menu shown below.
FORCE
POSITION OPT
MOVE SPD
SPEED
(4) Press the [F3] key (POSITION OPT) to display the menu shown below.
FORCE
STEP
LOW SPEED
SPEED
(5) Press the [F1] key (STEP) to display the step movement setting screen.
FORCE
STEP
SPEED
Use the [ ] or [
To cancel your selection, press the [NEXT] key.
Setting range: 5, 10, 25, 50, 100 (μm) [Default value: 5]
(6) Press the [PAUSE] key to cancel PAUSE mode.
This setting is retained in the plotter's internal memory even while the plotter is turned off.
] [ ] [
] [ ] [
OFFSET
HI SPEED
LCD•
QUALITY
OFFSET
OPTION2
QUALITY
OFFSET
TEST
QUALITY
OFFSET
HI SPEED
LCD•
QUALITY
OFFSET
5 um
QUALITY
] key to change the numeric value, and then press the [ENTER] key to confirm your selection.
] [ ] keys is pressed initially, the pen carriage moves only
] keys are used. Press the [F4] key to activate or deactivate this function.
] [ ] [ ] [ ] keys to move the pen carriage toggles the speed between
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
] [ ] [ ] [
•
], the coordinates during movement are
] keys are
5-25