Setting The Pen-Up Speed Mode - GRAPHTEC MP303-04 User Manual

2.6 Setting the Pen-Up Speed Mode

The pen in the raised status can be moved at the maximum speed of both the X and Y axes. Thus, plotting that
includes a lot of diagonal movement takes less time.
NOTE
This function is less effective for plotting that does not include much pen-raised movement.
I Procedure
(1) Press the
M O D E
(2) Press the
E N T E R
(3) Press the or
mode is currently set to NormalSp (normal speed).
(4) Press the or
affects the Pen-Up speed mode setting blinks).
HiSpeed : Selects high speed mode.
NormalSp : Selects normal speed mode.
(5) When the desired status is displayed, press the
(6) If the setting is correct, press the
to take effect.
To cancel the setting and return to Step (1), press the
key and then press the
key to display the command selection menu.
key until the Pen-up speed mode menu is displayed. In this example, the Pen-up speed
NormalSp
key to switch the Pen-Up speed mode between HiSpeed and NormalSp (the bit which
HiSpeed
ENTorCAN
E N T E R key. Pressing the key resets the plotter to allow your new setting
Ready Ready
or key to display the message below.
Setup
DipSW.
F P - G L
key. The prompt below appears.
E N T E R
Reset?
key.
C A N C EL
X=
or
Y=
2-8