Speed - Setting The Pen Up Speed - GRAPHTEC FC4100 series User Manual

SPEED - Setting the Pen Up Speed

To reduce the overall cutting time, this function allows you to set the traveling speed of the pen in
raised status, separately from the cutting SPEED setting.
Press the MENU key to select MENU mode.
Press the NEXT key.
Press the NEXT key again.
Press the NEXT key again.
Press the F3 key to select OPTION 1.
Press the F1 key to select PEN UP SPEED.
Press the UP or DOWN ARROW key to sequence
through the available choices.
The PEN UP SPEED can be set to AUTO or to 10, 20,
30, 40, 50 or 60 cm/s. When AUTO is selected the
PEN UP SPEED is set to match the current cutting
SPEED setting.
Press the ENTER key to register your settings.
Press the MENU key to cancel MENU mode.
NOTE: Your PEN UP SPEED setting is retained in the plotter's internal memory even while the
plotter is turned off.
Advanced Functions and Settings ♦ C4 - 32
OPTION 1>
OPTION 2>
PEN UP SPEED>
OFFSET ANGLE>
OFFSET FORCE>
STEP PASS>
PEN UP SPEED
SPEED= AUTO