Field Service Ver2.0 Aug.2005
3.17.12 Replacing the fusing claw /Up
A. Periodically replaced parts/cycle
•
Fusing claw /Up: Every 1,500,000 prints
B. Procedure
[1]
[2]
1.
Pull out the ADU from the main body. (See "3.16.1
Cleaning the registration sensor (PS44).")
2.
Remove the fusing unit. (See "3.17.1 Removing/
[2]
reinstalling the fusing unit.")
3.
Open the fusing paper exit section. (See "3.17.2
Opening/closing the fusing unit /Up.")
4.
Remove the springs [1], 1 each, and then remove
6 fusing claws /Up [2].
5.
Reinstall the above parts following the removal
steps in reverse.
57gaf2c020na
3. PERIODIC CHECK
167