Lift Tray Horizontal Adjustment Of The Trays 1, 2 And 3; Procedure - Konica Minolta bizhub PRO 920 Service Manual

11. MECHANICAL ADJUSTMENT

11.3 Lift tray horizontal adjustment of the trays 1, 2 and 3

When the lift wire is replaced or the lift tray is inclined, conduct this adjustment.
11.3.1

Procedure

[3]
[4]
434
[2]
[1]
57gaf3c013na
[3]
[4]
[1]
[2]
57gaf3c014na
Field Service Ver2.0 Aug.2005
1.
Pull out the paper feed tray. (See "6.3.18 Remov-
ing/reinstalling the paper feed tray 1 and 2," and
"6.3.20 Removing/reinstalling the paper feed tray
3.")
2.
If any paper remaining, remove it.
3.
In order to remove the tray with the lift tray
brought up, put the rubber eraser [2] under the
up/down drive connecting lever [1].
4.
With the tray set, check the lift tray to see if it has
completed the up operation by listening to the
operating sound of the paper lift motor, and then
pull out the tray again.
5.
Remove the tray. (See "6.3.18 Removing/reinstall-
ing the paper feed tray 1 and 2," and "6.3.20
Removing/reinstalling the paper feed tray 3.")
6.
While holding the pulley mounting bracket [1] by
hand, loosen the screw [2] and, with the marking
[3] used as a guide, make the lift plate [4] horizon-
tal.
7.
Tighten up the screw [2].
Note
• After completion of adjustments, be sure to
take off the rubber eraser set under the up/
down drive connecting lever.
8.
Place paper in it, and set the tray.
9.
Conduct the copy/print operation, and check to
see if paper is fed normally with no jam occurring.
10.
When the condition is not improved, repeat steps
1 to 9.