Stretching Of The Scanner Wire - Konica Minolta bizhub PRO 920 Service Manual

6. OTHERS
6.3.15

Stretching of the scanner wire

Note
• Be sure to wind the wire closely without overlapping each other.
• When re-stretching or replacing the scanner wire, be sure to use the optics unit positioning jig.
• When re-stretching or replacing the scanner wire, be sure to conduct the image adjustment in the
Tech. Rep. mode. (See chapter III "Adjustment/setting.")
A. Procedure
[3]
1.
Remove the original glass. (See "6.3.7 Removing/reinstalling the original glass.")
2.
Remove the upper cover /Lt. (See "6.3.8 Removing/reinstalling the upper cover /Lt.")
3.
Remove the operation panel. (See "6.3.10 Removing/reinstalling the operation panel.")
4.
Remove the original glass guide /Rr and Rt. (See "6.3.12 Removing/reinstalling the CCD unit.")
5.
Remove the exposure unit (See "6.3.14 Removing/reinstalling the exposure unit.")
6.
Move the V-mirror unit [1] toward the V-mirror positioning hole [2].
7.
Insert the optics unit positioning jig [3] into the V-mirror positioning hole [2] and fix the V-mirror unit [1].
Note
• Be sure to insert the optics unit positioning jig [3] from the front side and pass it through the V-mir-
ror unit [1].
• Be care full not to confuse the V-mirror positioning hole [2] with the unused hole [4].
252
1
[1] [2]
Field Service Ver2.0 Aug.2005
[4]
[3]
[3]
57gaf2c166na