Replacing The Fusing Unit - Konica Minolta bizhub C658 Service Manual

bizhub C658/C558/C458/C368/C308/C258
7.9 Fusing section
7.9.1 Replacing the fusing unit
• The temperature gets high in the vicinity of the fusing
unit. You may get burned when you come into contact
with the area.
Before replacement operations, make sure that more
than 20 minutes have elapsed since the main power
switch was turned off.
(1) Periodically replacing parts/cycle
• Fusing unit: Every 600,000 (bizhub C368)
• Fusing unit: Every 600,000 (bizhub C308)
• Fusing unit: Every 600,000 (bizhub C258)
(2) Procedure
1. Open the right door and the regist unit.
[2] [1]
[1]
[2] [1]
[3]
[3] [2]
[1] [4]
7. To reinstall, reverse the order of removal.
8. Carry out the [Service Mode] -> [Counter] -> [Life] ->
F PERIODICAL MAINTENANCE > 7. Periodical maintenance procedure bizhub C368/
CAUTION
[2]
[2]
[3]
[1]
[New
2. Remove the screw [1] each, and remove the two connector protective covers
[2].
3. Remove the harness from the wire saddle [1].
4. Disconnect three connectors [2].
5. Disconnect the connector [3].
NOTE
▪ When removing the connector [3], press the claw to release the
lock, then remove it.
6. Remove two screws [1], and remove the fusing unit [2].
NOTE
▪ When removing the fusing unit, hold the parts [3] shown on the
picture so that it would not fall.
▪ When installing the fusing unit, make sure that the set pin [4] is
inserted in the fusing unit.
Release].
F-36
C308/C258