Konica Minolta bizhub PRO 920 Service Manual page 415

Field Service Ver2.0 Aug.2005
*15 Fusing initial rotation condition
In the low temperature environment, fusibility may be
insufficient immediately after the power is turned ON.
So, rotate the fusing roller while in the warm-up to
obtain an even heat distribution of the fusing roller to
avoid the insufficient fusing.
• Low temperature: perform the fusing initial rotation
in the low temperature environment only.
• Low/normal temperature: perform the fusing initial
rotation in the low and normal temperature envi-
ronment
• Low/normal/high temperature: perform the fusing
initial rotation in all environments.
*16 Fusing roller initial rotation time
Set the preliminary rotation time for fusing when the
power is turned on.
*17 Message switchover
Set a message displayed on the operation board
when the key counter, coin vendor and the copy card
are used.
*18 Copy quantity limit
Set this when the number of copies for 1 job is lim-
ited.
Mode
Low temperature
Low/normal temperature
Low/normal/high temper-
ature
No preparatory rotation
Mode
180 seconds
300 seconds
60 seconds
0 second
Mode
Please insert key counter
Please insert copy card
Please insert coin
Please insert key counter
Mode
No limit
1 print
3 prints
5 prints
9 prints
10 prints
20 prints
30 prints
50 prints
99 prints
250 prints
No limit
No limit
No limit
No limit
10. TECH. REP. MODE
8-3 8-2
0 0
0 1
1 0
1 1
8-5 8-4
0 0
0 1
1 0
1 1
9-3 9-2
0 0
0 1
1 0
1 1
9-7 9-6 9-5 9-4
0 0 0 0
0 0 0 1
0 0 1 0
0 0 1 1
0 1 0 0
0 1 0 1
0 1 1 0
0 1 1 1
1 0 0 0
1 0 0 1
1 0 1 0
1 0 1 1
1 1 0 0
1 1 1 0
1 1 1 1
383