Konica Minolta bizhub PRO 920 Service Manual page 235

Field Service Ver2.0 Aug.2005
B. Setting of the communication method
(1) Setting up of the parallel port
When sending the parallel port data by using the ISWTrns, it is necessary to release the ECP mode setting of the
PC parallel port. The ISWTrns does not correspond to the data transmission for the parallel port in the ECP
mode. Accordingly, sending data in the ECP mode may result in an error while in transmission. Therefore, when
using the ISWTrns with the PC set in the ECP, it is necessary to release the ECP mode.
1) ECP port release procedure
The following procedure shows the release of the ECP mode.
Step
1 Start the PC.
2 Open "System" in "Control panel," select the "Device Manager" and search LPT1 in "Ports (COM &
LPT)."
• The LPT1 port is "ECP printer port (LPT1)," this is an ECP port.
• The LPT1 port is "Printer port (LPT1)," this is a normal parallel port.
3 When the printer port is set to the ECP port, change the BIOS setting of the PC to release the ECP
port.
Note
• The change of the BIOS varies depending on the PC. For release of the ECP mode, contact
the system administrator.
C. Firmware copy
By using the ISWTrns, firmware that transfers it to the main body is copied into the specified folder.
1) Procedure
Step
1 Start the PC.
2 Select "ISWTrns" from the start menu or double click the "ISWTrns" icon on the desktop to start up
the "ISWTrns."
3 Click [Option (O)] from the menu and then click [Option (O)].
4 "Option screen"
Click [Data Copy].
Operation
Operation
5. FIRMWARE VERSION UP
203