Replacing The Feed Input Gear - Konica Minolta bizhub PRO 920 Service Manual

Field Service Ver2.0 Aug.2005
3.13.6

Replacing the feed input gear

A. Periodically replaced parts/cycle
• Feed input gear: Every 15,000,000 prints
B. Procedure
[3] [1] [3] [4]
[2]
57gaf2c302na
1.
Remove the rear cover. (See "6.3.1 Removing/
reinstalling the rear cover.")
2.
Remove the right cover /Lw. (See "6.3.4 Remov-
ing/reinstalling the right cover /Lw.")
3.
Pull out the tray 3. (See "6.3.20 Removing/rein-
stalling the paper feed tray 3.")
4.
Remove the connector [1].
5.
Remove 4 screws [2].
6.
Release the 2 board supports [3] and remove the
paper feed motor assembly [4].
3. PERIODIC CHECK
97