Konica Minolta bizhub PRO 920 Service Manual page 298

6. OTHERS
[2]
[1]
[5]
[4]
266
[3]
[7]
[6]
57gaf2c267na
57gaf2c268na
Field Service Ver2.0 Aug.2005
6.
Remove the E-ring [1] and then remove the wire
correction cover [2] and the pulley [3].
7.
Remove the wire /2 [4] from the fixing plate [5].
8.
Following steps 3 to 7, remove the wire /3 [6] and
the wire /4 [7] on the rear side.
Note
• The wire length of the tray 3 is as shown
below. The wire length of the tray 3 is different
from those of the trays 1 and 2 and be careful
not to confuse one with the other.
Wire /1 and /3: 309 ± 1 mm
Wire /2 and /4: 599 ± 1 mm
9.
Reinstall the above parts following the removal
steps in reverse.