Konica Minolta bizhub PRO 920 Service Manual page 486

12. JAM CODE
Classifica- Jam code
tion
FS J72-16
J72-17
J72-18
J72-19
J72-20
J72-21
J72-22
J72-23
J72-24
J72-25
J72-26
454
1
Cause
The FS entrance sensor (PS4) does not
turn ON within a specified period of
time after the paper exit sensor (PS61)
turns ON.
The sub tray paper exit sensor (PS1)
does not turn ON within a specified
period of time after the FS entrance
sensor (PS4) turns ON. (Shift mode)
The stacker entrance sensor (PS5)
does not turn ON within a specified
period of time after the FS entrance
sensor (PS4) turns ON. (while in sta-
pling)
The stacker entrance sensor (PS5)
does not turn OFF within a specified
period of time after the PS5 turns ON.
The main tray paper exit sensor (PS6)
does not turn ON within a specified
period of time after the start of exiting
paper (while in stapling).
After start of the paper exit operation,
the main tray paper exit sensor (PS6)
does not turn OFF within a specified
period of time. (While in the staple)
The sub tray paper exit sensor (PS1)
does not turn ON within a specified
period of time after the FS entrance
sensor (PS4) turns ON (while in exiting
paper in the sub tray).
The sub tray paper exit sensor (PS1)
does not turn OFF within a specified
period of time after it turns ON (while in
exiting paper in the sub tray).
The folding passage sensor (PS26)
does not turn ON after stapling is com-
pleted. (FS-604 only)
The folding paper exit sensor (PS25)
does not turn ON within a specified
period of time after completion of the
folding operation. (FS-604 only)
The folding paper exit sensor (PS25)
does not turn OFF within a specified
period of time after it turns ON. (FS-604
only)
Field Service Ver2.0 Aug.2005
Resulting Correction
operation
The FS/main Remove jammed paper
body stop if any from the FS/main
immediately. body.