3. PERIODIC CHECK
74
[1]
57gaf2c101na
Field Service Ver2.0 Aug.2005
Note
• After replacing the cleaning blades /1 and /2,
be sure to check to see if the blade replace-
ment lever [1] has been pulled (cleaning
blades /1).
• After replacing the cleaning blades /1 and /2,
be sure to conduct the blade set mode in the
Tech. Rep. mode to prevent the blade from
curling up. (See "10.4.9 Blade setting mode
(drum peculiarity adjustment)" in Field Serv-
ice.)
• Be sure to avoid using the blade set mode
other than when replacing the cleaning blade.
Otherwise, the cleaning blade counter of the
fixed parts counter is reset so that the blade
is not replaced automatically at the correct
timing.
11.
Reinstall the parts after that following the removal
steps in reverse.