Konica Minolta bizhub PRO 920 Service Manual page 285

Field Service Ver2.0 Aug.2005
[3]
[5]
[14]
[17]
[16]
[18]
[10]
8.
Drop the metal ball [3] in between the scanner wire /Fr [1] and /Rr [2] into the installation hole of the drive pul-
ley [4]. And with this hole as a starting point, wind the wire 4 turns [5] outwards and 5 turns [6] inwards.
Note
• Be sure to wind the scanner wire with the metal ball [7] at the end outwards and the scanner wire
with the wire terminal [8] at the end inwards.
• For both scanner wires, be sure to pull out the one wound outwards in the paper feed direction [9]
from above the drive pulley and the one wound inwards in the paper exit direction [10] from above
the drive pulley.
9.
For each scanner wire that has been wound round the drive pulley, fasten it to the respective wire stoppers
through the wire stopper /Fr [11] or /Rr [12] pulley /1 [13] and via the outside of the pulley [15] of the V-mirror
unit [14].
Note
• Each wire stopper is provided with 2 grooves. Fix the metal ball [7] in the groove on the outside for
the wire stopper /Fr [11], and fix it in the groove on the inside for the wire stopper /Rr [12].
[6]
[22]
[15]
[8]
[21]
[8]
[20]
[18]
[17]
[16]
[7]
[12]
[2]
[22]
[4]
[4]
[15]
6. OTHERS
[6]
[3]
[5]
[13]
[9]
[13]
[1]
[11]
[7]
[11]
57gaf2c167na
253