Konica Minolta bizhub PRO 920 Service Manual page 136

3. PERIODIC CHECK
[3]
[8]
[4]
104
[1]
[2]
[5]
[4]
[6]
[7]
57gaf2c183na
[3]
[2] [1]
57gaf2c184na
Field Service Ver2.0 Aug.2005
4.
Pull up the separation roller unit assembly [1].
5.
Remove the C-clip [2] and then remove the sepa-
ration roller unit [3].
Note
• The shaft [4] of the separation roller unit is
inserted with the spacer [5]. Be careful that it
does not get lost.
• When installing the separation roller, be sure
to insert the projection [8] into the stopper [7]
of the spring [6].
6.
Remove the C-clip [1] and then remove the sepa-
ration roller unit [2].
Note
• When installing the separation roller, be sure
to install it so that the paint mark [3] comes to
the torque limiter [4] side.
• When installing the separation roller, be sure
to check to see if the separation roller is not
smeared with grease.