Field Service Ver2.0 Aug.2005
6.3.21
Removing/reinstalling the paper feed tray 3 lift wire
Note
• When there remains any paper in the tray, be sure to take off all of it before starting the work.
• After completion of the replacement or retightening of the wire, rotate the gear of the paper lift
unit to check to see if the tray goes up and down smoothly.
• Make sure that the wire does not cross or get on another wire.
• After installing the wire, be sure to adjust the tilt of the tray. (See "11.4.1 Pre-registration roller
skew adjustment of the trays 1, 2 and 3.")
A. Procedure
[7]
[6]
[8]
[6]
[7]
[5]
[4]
[3]
[6]
[7]
[2]
[1]
57gaf2c266na
1.
Remove the tray. (See "6.3.18 Removing/reinstall-
ing the paper feed tray 1 and 2.")
2.
Remove the tray cover and then remove the
paper lift unit. (See "3.13.5 Replacing the pre-reg-
istration roller (Trays 1, 2, 3).")
3.
Remove the E-ring [1] and then remove the drive
pulley [2].
4.
Remove the E-ring [3] and then remove the wire
correction cover [4] and the pulley [5].
Note
• Be sure to install the wires /1 [6] and /2 [7] so
that the wire /2 comes inside. And make sure
that the wires do not cross each other.
5.
Remove the wire /1 [6] from the fixing plate [8].
6. OTHERS
265