Body Final Installation - Factory Five Racing GTM Supercar Assembly Manual

Body Final Installation


1 / " drill bit, drill, silicone, caulking gun, flathead screwdriver,
8
Tape, Phillips head Screwdriver, wire strippers.

Aluminum Panel – Firewall, Fuel Filler Assembly, Rubber Push on Trim, Aluminum Panel – Rear
Deck Trim Plate, Headlight Plugs
Install the fuel filler caps in the position you drilled before the body was painted and bolt in place using
the hardware that came with the caps (Phillips screwdriver,
Re-install the body following the same steps as before but being extra careful this time with all painted
surfaces.
We will often tape door and window openings with masking tape while lining up panels to prevent from
scratching the opening during adjustment. 3M blue painters tape (#2080) works well and is easy on fresh
paint.
5
622
www.factoryfive.com 508-291-3443
5 / " socket, ratchet, Low-Tack
16
/ " wrench/socket).
16