Table of Contents
Advertisement
Remove the Driver Side Tunnel Vinyl and set in place on the tunnel. Make sure you have enough
material to wrap around the 1" square steel dash upright and onto the floor (the carpet will overlap the
excess vinyl). Once the vinyl is situated in the right manner, tape the top edges, and the rear edge in
place.
Tape the top edge of the vinyl at the front of the footbox in place.
Now you will need to identify the areas where you will need to cut a slit in the material – this helps the
material set in place properly. Begin by marking the cut line along the edge of the Dash X where the
footbox begins. A good way to be sure you are on the edge is to press the marker along the edge of the
567
www.factoryfive.com
508-291-3443
Advertisement
Table of Contents
