Rear Quarter Floor (R, L) - Factory Five Racing GTM Supercar Assembly Manual

Rear Quarter Floor (R, L)

Tape the one of the Rear Quarter Floor Panels into place, lining it up with the 1.5" square tube that runs
along side the engine, and the diagonal 1" square tube in front of the rear wheel. The front edge of the
panel should be in the middle of the 1.5" square tube that runs the width of the car, under the crankshaft
pulley. Trace the outline of the steel.
Remove the panel and mark the rivet locations. Drill out the panel.
Apply silicone to the frame and re-tape the panel into position. Drill and rivet the panel to the frame.
Repeat for the other side.
602
www.factoryfive.com 508-291-3443