Factory Five Racing GTM Supercar Assembly Manual page 433

The fuel filter is installed under the PCM on top of the fuel tank finish panel (just forward of the engine
fuse box). Install a ¼-20" rivnut into the frame then attach the fuel filter to the frame using the flanged
button head fastener (FFR# 25460). The filter should be oriented with the output of the filter facing the
motor.
Connect the output on the fuel filter to the input on the motor, large 10mm port on the fuel rail. The fuel
filter output requires a 10mm male fitting which is cut off of the hard Corvette nylon coated fuel lines.
Cut a short section (1.25" from the ridge) off one of these lines. Using a flaring tool slightly flare the end
of this adapter piece.
Trim a small section of the nylon coating off of the line – this will provide a better seal when you clamp
the flexible hose onto it.
424
www.factoryfive.com 508-291-3443