Cockpit/Tunnel Aluminum - Factory Five Racing GTM Supercar Assembly Manual

Loop the cables forward and attach the ends into the emergency brake connection bracket.

Cockpit/Tunnel Aluminum


Eye protection, drill w/#6 hex nut driver, ⅛" drill bits, drill, rivet gun, silicone, caulking gun, #6
self tapping screws.

Rear cockpit lumbar aluminum (FFR# 25156).
Using the previously described aluminum installation process install the rear driver (FFR# 25163) and
passenger aluminum (FFR# 25164) panels. The cutout is located on the passenger side to give clearance
for the HVAC compressor. Do not rivet the front edge (arrow) of these panels, because it is riveted in the
next step. (same procedure used on driver and passenger side)
320
www.factoryfive.com 508-291-3443