Front Wheel Well Rear Splash Guard Aluminum - Factory Five Racing GTM Supercar Assembly Manual

Drill the panel according to the marks you made, apply silicone to the frame/mounted aluminum, and rivet
the panel in place.

Front Wheel Well Rear Splash Guard Aluminum


Eye protection, drill w/#6 hex nut driver, ⅛" drill bits, drill, rivet gun, silicone, caulking gun, #6
self tapping screws.

Driver/passenger front wheel well rear splash guard aluminum (FFR# 26025, 26026), aluminum-
body seal, rubber push on trim (FFR# 26035(same as 10761)).
With the main body shell in place, using the aluminum installation techniques previously described
(aluminum removal and installation) we will now install the front wheel well rear splash guards. Drivers
side shown, bends are forward.
704
www.factoryfive.com 508-291-3443