Table of Contents
Advertisement
Drill a
3
/
" hole through the flat faces of the shaft ½" in from the end of the shaft.
8
Slide the lower shaft back over the upper shaft and re-create the factory stop.
If you are preparing the donor parts before receiving your kit, the following steps can be done
once the column is in the car, but it is easier to perform them with the column off the car.
Put the Tilt head and shaft assembly back into the telescoping sleeve.
Install the tilt pins using the opposite procedure of when you removed them (including pressing the
material slightly over the face of the pin with a punch/chisel).
Install the tilt spring.
Seat Belts
Razor, 18 mm wrench or socket/ratchet, T-15 Torx, ½" drill bit, drill.
Seat Belt Hardware (FFR# 25415), Passenger and Driver Seat Belt Assemblies.
Prior to using a donor mechanism, inspect the seat belts themselves. Do not use the seatbelt if
the stitching is badly worn, weakened or torn.
There are white plastic caps covering the seatbelt retracting mechanism. Remove the caps by unbolting
the three small Torx bolts with a T-15 Torx bit.
177
www.factoryfive.com
508-291-3443
Advertisement
Table of Contents
